The self loading mixer has the advantages of fast and clean discharge, convenient maintenance, time-saving and labor-saving, ensuring that the concrete carried will not solidify; it is widely used in construction enterprises such as expressways, bridges, power stations, dam construction projects and large and medium-sized prefabrication plants. The concrete self loading mixer should be cleaned every day. The concrete solidifies in the mixing tank. If it takes a long time, it will cause corrosion. The car will get heavier and heavier if it doesn't clean for a long time. Here is everyone's daily cleaning procedure.

1、自上料赢咖7注册每次灌装前用水冲洗进料口，以便在灌装过程中保持进料口湿润。

1. Flush the feeding port with water before each filling from the feeding mixer, so as to keep the feeding port moist during the filling process.

2、在装载的同时，将装有车辆的洗涤水箱装满水。

2. At the same time of loading, fill the washing water tank with water.

3、充电后冲洗进料口，清洗进料口附近残留的混凝土。

3. After charging, flush the inlet and clean the residual concrete near the inlet.

4、在施工现场卸载后，冲洗排放槽，然后在全自动混凝土搅拌槽中加入30-40L清洗水；在自上料赢咖7注册辆返回时保持混凝土储罐缓慢旋转。

4. After unloading at the construction site, flush the discharge tank, and then add 30-40l cleaning water into the automatic concrete mixing tank; keep the concrete tank rotating slowly when returning from the loading mixer vehicle.
              

5、在下次装货前，记得放下自动混凝土搅拌槽中的污水。

5. Before the next loading, remember to put down the sewage in the automatic concrete mixing tank.

6、每天清洁自上料赢咖7注册搅拌槽和工作周围的进出口，确认没有水泥和混凝土结块。

6. Clean the inlet and outlet around the mixing tank and working area of the self feeding mixer every day to make sure there is no cement and concrete caking.

自动混凝土赢咖7注册对叶片的形状、布局及其在拌筒内的位置进行了专门的设计，使得匀质性好、进出料速度快，出料残余率低。转动部分是故障多发部位，应按时加注润滑脂，并经常检查磨损情况，及时修理更换。保障液压油清洁，流动式自上料赢咖7注册工作环境恶劣，要防止污水泥沙进入液压系统。液压油要按使用手册要求定期更换。一旦检查时发现液压油中混入水或泥沙，就要立即停机清洗液压系统、更换液压油。

The shape, layout and position of the blades in the mixing drum of the automatic concrete mixer are specially designed, which makes the uniformity good, the feeding and discharging speed fast and the discharging residual rate low. The rotating part is the fault prone part, so the lubricating grease should be added on time, and the wear condition should be checked frequently, and the repair and replacement should be carried out in time. Ensure that the hydraulic oil is clean, the working environment of the mobile self feeding mixer is bad, and prevent the dirty cement sand from entering the hydraulic system. The hydraulic oil should be changed regularly according to the manual. Once the hydraulic oil is found to be mixed with water or sediment, it is necessary to stop the machine immediately to clean the hydraulic system and replace the hydraulic oil.

自上料赢咖7注册应该注意平时清洁。如果长时间不清洁，会对车辆造成损坏，大大缩短自动混凝土赢咖7注册的使用寿命。

The self feeding mixer should be clean at ordinary times. If it is not cleaned for a long time, it will damage the vehicle and greatly shorten the service life of the automatic concrete mixer.