1. Maintenance and inspection of battery: check whether the battery is fixed firmly.

2、轮胎的检查：每月应在常温下检查一下轮胎气压。

2. Tire inspection: check the tire pressure at normal temperature every month.

3、离合器总泵液面的检查：离合器液面介于高、低液面间则表示正常，如果低于标准线，则可能是总泵或分泵皮碗损坏。

3. Inspection of clutch master cylinder liquid level: if the clutch liquid level is between high and low, it indicates that it is normal. If it is lower than the standard line, the master cylinder or slave cylinder cup may be damaged.

4、制动液面的检查：制动也在高、低位之间则表示正常。

4. Inspection of brake fluid level: if the brake is also between high and low, it means normal.

自动上料赢咖7注册运输中的防护要注意什么？

What should be paid attention to in the transportation of automatic feeding mixer?

5、发动机冷却液液面检查：发动机在热机状态时，千万不要打开散热器盖，否则可能会被溅出的冷却液或高温蒸气烫伤。等发动机冷却后，检查冷却液的液面应处于满位和低位之间，否则应加蒸馏水或纯净水或冷冻液，加水后的液面高度不能超过满位。如发现短时间内冷却液减少的很快搅拌，自动上料搅拌车检查步骤应检查冷却系统是否有泄漏或到维修站去检查。

5. Engine coolant level inspection: never open the radiator cap when the engine is hot, otherwise you may be scalded by splashed coolant or high-temperature steam. After the engine is cooled, check that the liquid level of the coolant should be between the full level and the low level, otherwise distilled water or purified water or refrigerant should be added, and the liquid level after adding water should not exceed the full level. If it is found that the coolant decreases quickly in a short time, the inspection steps of the automatic feeding mixer shall check whether there is leakage in the cooling system or go to the maintenance station for inspection.

自动上料赢咖7注册操作环境通常都不是很好，这也导致需要我们对设备在操作之前有详细的了解才行。在确保设备不存在有任何故障问题之后才能够操作使用设备正常运行，避免在操作中可能存在的各种不良问题。

The operating environment of automatic feeding mixer is usually not very good, which also requires us to have a detailed understanding of the equipment before operation. The equipment can be operated and used only after it is ensured that there is no fault problem, so as to avoid various adverse problems that may exist in operation.