赢咖7注册重新投入使用前要检查的十件事
来源：http://www.yuanmei168.com/日期：2022-06-06
1、检查机油、柴油、转向油、离合器油、刹车油和发动机冷却液的加注情况，确保车辆正常使用，并更换和清洗机油滤清器、柴油机及时过滤和空气过滤器。
1. Check the filling of engine oil, diesel, steering oil, clutch oil, brake oil and engine coolant to ensure the normal use of the vehicle, and replace and clean the engine oil filter, diesel engine timely filter and air filter.
2、检查转向系统、离合器、制动系统是否工作正常。检查照明、报警器、方向灯、刹车灯、雨刮器等工作是否正常，并进行清洁。检查轮胎气压是否正常，是否有裂纹或损坏，轮胎螺母是否松动。
2. Check whether the steering system, clutch and braking system work normally. Check whether the lighting, alarm, direction light, brake light, wiper, etc. work normally and clean them. Check whether the tire pressure is normal, whether there is crack or damage, and whether the tire nut is loose.
3、检查完毕后，启动车辆暖机，检查油压、发动机水温是否正常，底盘气路是否漏气。
3. After the inspection, start the vehicle to warm up, check whether the oil pressure and engine water temperature are normal, and whether the chassis air circuit leaks.
4、用尿素检查车辆。发动机关闭少30秒后，请勿关闭车辆主电源。此时系统会将残留的尿素溶液从管道中排出，防止结晶物堵塞喷嘴。
4. Check the vehicle with urea. Do not turn off the main power supply of the vehicle after the engine has been turned off for at least 30 seconds. At this time, the system will discharge the residual urea solution from the pipe to prevent the crystal from blocking the nozzle.
5、检查混凝土赢咖7注册的液压泵、电机、减速机是否漏油，液压油、减速机齿轮油是否充足，是否有变质，液压油滤芯是否符合使用要求，液压油散热器是否能工作一般。
5. Check whether the hydraulic pump, motor and reducer of the concrete mixer leak oil, whether the hydraulic oil and reducer gear oil are sufficient and deteriorated, whether the hydraulic oil filter element meets the use requirements, and whether the hydraulic oil radiator can work normally.
6、检查主副车架的连接螺栓是否松动、脱落；副车架和底盘横梁是否开裂。
6. Check whether the connecting bolts of the main and subframe are loose and fall off; Whether the subframe and chassis crossmember are cracked.
7、检查滚道和托辊表面是否有异物，及时；转动搅拌筒，检查是否有晃动、异响等；检查托辊的紧固螺栓是否松动，托辊是否移位；支撑辊的内侧。
7. Check whether there are foreign matters on the surface of the raceway and idler, and remove them in time; Rotate the mixing drum to check whether there is shaking, abnormal noise, etc; Check whether the fastening bolts of the idler are loose and whether the idler is displaced; Inside of support roll.
8、检查进料斗、溜槽有无结块并；溜槽伸缩支架转动时，检查伸缩支架是否正常膨胀，并在伸缩支架和支撑摇杆上加注润滑脂。
8. Check whether the feeding hopper and chute are caked and remove them; When the chute telescopic support rotates, check whether the telescopic support expands normally, and fill the telescopic support and the support rocker with grease.
9、检查传动轴的连接螺栓是否松动，并在传动轴的花键和横轴上加注润滑脂。
9. Check whether the connecting bolts of the transmission shaft are loose, and add grease to the splines and horizontal shafts of the transmission shaft.
10、检查的旋转控制手柄的操作是否卡住，并在油嘴内加注润滑脂。
10. Check whether the operation of the rotary control handle of the concrete mixer is stuck, and fill the grease in the nozzle.
以上是赢咖7注册重新投入使用前要检查的十件事的相关内容，希望能帮助到你。更多相关内容就来我们网站进行咨询了解吧！
The above is the relevant content of the ten things to check before the mixer is put into use again. I hope it can help you. For more information, please visit our website at www.zkhntjbj Www. 68mn. Com!
全国服务热线
点击拨打服务热线：400--555-666
